Installation Instructions

Thanks for choosing EB Graphics for your wrap install.

Some notes to help:

There is a squeegee tool in the box, other things you will need are a sharp Stanley knife, masking tape, heat gun, wax and grease remover.
Tape all the pieces on the car first so you can work out positioning.
Check you have the pieces in the right spot to the design proof I sent through
The side pieces/wing pieces will be bigger than the panel, so trip those back after you have installed.
Try a small piece first and build up to the larger pieces so you can learn how it works.

**Do not put water/soapy water on the wrap this will damage the adhesive.
**Install indoors out of the wind and direct sunlight, its best to install around 20-25 Degrees.